Heathrow Scientific vortexer Manual De Instrucciones página 3

19. Do not operate in a hazardous or flammable environment.
20. Do not use any solvent on the unit that may degrade the plastic of the Vortexer main
housing or head.
21. Ensure the mixing head is protected from corrosion and mechanical damage. The mixing
head must be cleaned with a pH-neutral cleaning liquid.
22. Always work in a manner which endangers neither the user nor any other person.
23. Should the instrument fail to work to specification, immediately stop vortexing. Contact the
authorized dealer or the manufacturer if trouble persists.
24. Do not attempt to make contact with the mixing head attachment while unit is running.
Doing so may cause the unit to fail and will void the warranty.
25. Only use original manufacturer's mixing head attachment, AC adapters, and any other spare
parts.
26. If unit is malfunctioning or needs to be returned, please contact either the authorized dealer
or Heathrow Scientific
27. Improper use of the Vortexer instrument will void the warranty. If there is a failure during the
warranty period, contact Heathrow Scientific
28. Do not attempt to use units that have not been correctly installed or repaired.
29. Do not attempt to disassemble or modify this product.
30. Store at room temperature in a dry area. Do not expose to sunlight, moisture, or extreme
temperatures for prolonged periods of time.
31. Before using any cleaning or decontamination methods please contact Heathrow Scientific
LLC to ensure that the proposed method will not damage the equipment. A pH-neutral
cleaning liquid mus be used.
32. Vortexer must be unplugged from electrical source before any cleaning or maintenance
is performed.
Attention:
If main electrical power is interrupted, Vortexer device will immediately
begin operating if 3-position switch has not been set to OFF position when power is
restored.
If power is interrupted:
1) Unplug cord from back of device
2) Set Vortexer switch to OFF
Warning!
• If the unit is not used as recommended by the manufacturer, the overall safety
will be impaired.
• Check MSDS, wear required Personal Protective Equipment, and observe all
applicable local and national regulations before dispensing and disposing of
hazardous samples.
• The laboratory procedure should ensure that no person or hazardous substances are
present within a 12" (30cm) zone around the Vortexer instrument when operating.
• This product does not contain bio-seals as per IEC/EN/CSA 61010-2-20 and cannot
provide any level of containment in case of a spill or release of toxic, radioactive, or
pathogenic micro-organisms thus these materials are not recommended to be used in
this product.
® LLC .
To immediately shut off power to Vortexer device, pull out the
AC cord from the lower central back area of the device
® LLC for warranty service.
®
3