Heathrow Scientific vortexer Manual De Instrucciones página 6

Your Vortexer is supplied with a pop-on mixing head
attachment and an AC power cord located in the top
corrugated box insert
you fully unpack your Vortexer from the package and
remove the protective plastic bag, install the mixing head
attachment (check that it is right side up).
IMPORTANT:
YOU MUST PULL OUT INNER FRONT
SUPPORT CARD
HEATHROW SCIENTIFIC
HANDS TO GRASP THE UNIT WHEN LIFTING
OUT OF THE BOX.
TO INSTALL THE MIXING HEAD ATTACHMENT YOU
MUST PRESS DOWN FIRMLY WITH BOTH HANDS
UNTIL YOU FEEL THE MIXING HEAD ATTACHMENT
SNAP FULLY INTO PLACE.
This will ensure that the mixing head attachment will not
come off the Vortexer during operation.
Place the Vortex Mixer on a level, stable surface near the
grounded electrical outlet. The surface should be clean and
free of dust to ensure that the feet grip the surface firmly.
Allow sufficient clearance on all sides of the unit for proper
ventilation and usage. With the power switch in the OFF
position (central on the vertical 3-position), plug the power
cord into the back of the Vortex Mixer. Have the speed
rotary dial turned all the way to the left- (in the OFF
position). Plug the device into a properly grounded outlet.
power
switch in
the OFF
position
- center
Modes of Operation:
WARNING:
110V-120V Vortexer: Recommended maximum run time of 60 minutes
in Continuous Operation mode. If the Vortexer is used in a manner not
specified by Heathrow Scientific, the protection provided by the equipment
may be impaired.
100V-110V Vortexer: Recommended maximum run time of 45 minutes in
Continuous Operation mode. If the Vortexer is used in a manner not specified by
Heathrow Scientific, the protection provided by the equipment may be impaired.
6
of the product packaging. After
1
BEFORE REMOVING YOUR
3
VORTEXER. USE TWO
®
4
back view of Vortexer
1
2
3
4
apply even pressure to ensure
the head is secure
To immediately shut
off power to Vortexer
device, pull out the
AC cord from the
lower central back
area of the device