Replacing The Igniter Battery; Outdoor Grill Care; General Cleaning - Kitchen Aid 730-0893G Instrucciones De Instalación Y Manual De Uso Y Cuidado

Replacing the Igniter Battery

If igniters stop sparking, the battery should be replaced.
1. The igniter button cap is located on the outside of the
grill's right side panel.
2. Unscrew igniter button cap counterclockwise to remove.
A.
B.
3. Remove battery from the battery compartment.
4. Replace with a new alkaline "AA" size battery. Install
battery with negative end in first.
5. Screw igniter button cap clockwise into place.

General Cleaning

IMPORTANT: Before cleaning, make sure all controls are off
and the grill is cool. Always follow label instructions on
cleaning products.
For routine cleaning, wash with soap and water using a soft
cloth or sponge. Rinse with clean water and dry at once with a
soft, lint-free cloth to avoid spots and streaks.
Do not use steel wool to clean the grill, as it will scratch the
surface.
To avoid weather damage to finish, use grill cover.
STAINLESS STEEL
IMPORTANT: To avoid damage to stainless steel surfaces, do
not use soap-filled scouring pads, abrasive cleaners, cooktop
polishing creme, steel wool, gritty wash cloths or paper towels.
Cleaner should not contain chlorine. Damage may occur.
Food spills should be cleaned as soon as entire grill is cool.
Spills may cause permanent discoloration.
Cleaning Method:
Rub in direction of grain to avoid scratching or damaging

the surface.
Stainless steel cleaner.

Liquid detergent or all-purpose cleaner.

Rinse with clean water and dry with soft, lint-free cloth.

Vinegar to remove hard water spots.

Glass cleaner to remove fingerprints.


OUTDOOR GRILL CARE

"AA" size battery
Igniter cap
GRILL GRATES
IMPORTANT: Immediately after you are finished cooking, turn
all burners to HIGH for 10-15 minutes with the hood closed to
burn off food residue. Turn off all burners, raise the hood and
let the grates cool. When completely cool, grill racks can be
removed for thorough cleaning. Clean them with a mild
detergent and warm water. For baked-on food residue,
prepare a solution of 1 cup (240mL) ammonia to 1 gal. (3.75 L)
water. Soak grates for 20 minutes, then rinse with water and
dry completely.
WARMING SHELF
Cleaning Method:
Liquid detergent or an all-purpose cleaner.

Rinse with clean water and dry with soft, lint-free cloth.

For tough spots or baked-on grease, use a commercial

degreaser.
IMPORTANT: Make sure gas supply is off and all control
knobs are in the "○" position.
EXTERIOR
The quality of this material resists most stains and pitting,
providing that the surface is kept clean, polished and covered.
Cleaning Method:
Apply stainless steel polish to all non-cooking areas

before first use. Reapply after each cleaning to avoid
permanent damage to surface.
Cleaning should always be followed by rinsing with clean

warm water. Wipe the surface completely dry with a soft
cloth.
For tough spots or baked-on grease, use a commercial

degreaser stainless steel.
INTERIOR
Discoloration of stainless steel on these parts is to be
expected, due to intense heat from the burners. Always rub in
the direction of the grain. Cleaning should always be followed
by rinsing with clean, warm water.
Cleaning Method:
Liquid detergent or all-purpose cleaner.

Rinse with clean water and dry completely with a soft,

lint-free cloth.
A heavy-duty scrub sponge can be used with mild

cleaning products.
For small, difficult-to-clean areas, use a commercial

degreaser designed for stainless steel.
38