Scan Tag Channels; Set / Cancel Single Tag Channel; Set / Cancel All Tag Channels; Scan Operation - JOPIX MARINE 515P Manual De Instrucciones

9.13.- SCAN TAG CHANNELS:

For more efficient scanning, set the desired channels as TAG channels or clear the TAG
setting from unwanted channels. Channels that are not tagged will be skipped during
scanning.

9.13.1.- Set / cancel single TAG channel:

1. Push [CH] to select desired channel group.
2. Push [▲] or [▼] key to select the desired channel to be set as a TAG channel.
3. Push and hold [FAV/TAG] key for 1.5 seconds, to set the displayed channel as a TAG
channel.
● "TAG" appears in the function display.
4.- To cancel the TAG channel setting, push and hold [FAV/TAG] for 1.5 seconds.
● "TAG" disappears.
9.13.2.- Set / cancel all TAG channel:
1. While pushing and holding [FAV/TAG] key, press [ ] to clear all TAG channels in the
selected channel group.
2. Repeat above procedure to set all channels as TAG channels.

10.- SCAN OPERATION:

Set scan resume timer in the set mode.
1. Push [SCAN] key to start normal scan or priority scan.
● "SCAN" blinks.
● "16" appears on the sub-channel readout during a priority scan.
● When a signal is received, the scan pauses until the signal disappears, or resumes after
pausing 5 seconds, depending on the set mode setting.
● Channel 16 is monitored during priority scan.
● Push [▲] or [▼] key to sequentially select TAG channels, change the scanning direction
or manually resume the scan.
2. Push [SCAN] to stop the scan, or push [PTT], [16], [CH] or [FAV] also can stop the
scan.
English - 18 -