Troubleshooting - JOPIX MARINE 515P Manual De Instrucciones

15.- TROUBLESHOOTING:

The problems described in the following table are some common operational failures.
These types of errors are generally due to improperly connection, the operation caused by
incorrect setting, or operator error caused due to incomplete programming. These
problems are usually not caused by a transceiver failure. Before suspect that the
transceiver is damage, refer to the relevant section of this manual.
PROBLEM
The transceiver cannot
be turned on.
The transceiver does not
transmit, or does
transmit with high power.
The channel cannot be
changed.
Scan does not start.
Cannot communicate in
same channel.
No beep tone.
No sound
loudspeaker.
If you continue to have problems with the transceiver, consult the Technical
Service or salesperson.
POSSIBLE CAUSE
The
●
exhausted.
● The battery pack is not
correctly inserted.
Some channels
●
limited to
transmitting.
The
●
not exhausted.
● The output power is set
to low.
Working
●
channel or CH 70.
● The keypad lock function
is enabled.
● No TAG channels are
set.
● It is duplex channel.
● Work in self-set channel
group.
● Beep function is turned
off.
● The squelch level is too
high.
from ● The volume level is too
low.
Speaker
●
exposed to water.
English - 25 -
POSSIBLE SOLUTION
battery is ● Recharge the battery pack.
● Correctly insert the battery
pack.
are ● Switch to channels without
low power output power limited.
● Recharge the battery pack.
battery is ● Push [H/L] key to select high
output power.
● Quit weather channel or CH
70.
in weather
● Hold [LOCK] ley for 1.5
seconds to turn off the function.
● Set desired channels as TAG
channels.
● Choose channel.
● Set channel frequency as
same.
● Turn on the beep function in
set mode.
● Set suitable squelch level.
● Push [VOL] key, then [▲] /
[▼] key to adjust volume.
●
has been speaker grill.
Discharge water from