Characteristics; Characteristics Of Construction; Electrical Characteristics; Environmental Conditions - Chauvin Arnoux K Serie Manual De Instrucciones

3.1 CHARACTERISTICS OF CONSTRUCTION

Housing black plastic rigid shell
Dimension 103 x 64 x 28 mm
Mass approx. 200 g

3.2 ELECTRICAL CHARACTERISTICS

Input 230 V AC / 50 Hz / 30 mA AC / 6.9 V A
Output 9 V DC / 150 mA DC / 1.35 W

3.3 ENvIRONMENTAL CONDITIONS

The adapter must be used in the following conditions:
Use
Level of pollution
Altitude

3.4 COMPLIANCE WITH INTERNATIONAL STANDARDS

This instrument complies with the safety standard IEC 61010-1 (Ed. 2 of 2001) for 300 V installations in
category II on the mains supply side and up to 600 V in category III on the measurement device side.
Note:
The installation of the mains adapter does not change the standardised safety characteristics indicated
for the measurement device only. Below are the characteristics of the electrical housings:
Type of device
Series K
Series MA100
Series MA200
Series AmpFLEX A100
To clean the mains adapter, proceed as follows:
Disconnect everything connected to the device and set the switch to OFF.

Use a soft cloth, dampened with soapy water. Rinse with a damp cloth and dry rapidly with a dry cloth

or forced air.

3. CHARACTERISTICS

indoors
2
< 2000 m
Standardised characteristics
300 V CAT II
600 V CAT III

4. MAINTENANCE

10