Presentation; Use - Chauvin Arnoux K Serie Manual De Instrucciones

1. PRESENTATION

The mains adapter is an accessory that is used to supply your sensor or probe from a mains plug.
It consists of a mains unit, a connection cable and a semi-housing. This accessory is designed for use
on K housings.
Figure: the outer and inner sides of the adapter housing:
2
1
Outer side Inner side

2. USE

To install the adapter, proceed as follows:
Step 1:
Make sure that your device is not connected to an installation or measurement device.
Step 2: Remove the housing.
1. Use a screwdriver to unscrew the two screws at the back of the housing.
2. Open the housing.
3. Remove the battery.
Step 3: Install the adapter.
1. Connect the 9 V battery connector to the terminals inside the adapter housing (see above figure, ref.2).
2. Set the switch to OFF.
3. Close the housing and screw both screws back in.
4. Select the label in accordance with your model and affix the label to the front of the housing
(see above figure, ref.1).