Instruction Manual - flow-med u-sonic 2 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 10
EN

INSTRUCTION MANUAL

Perfect cleansing and care by power-ultrasonic
Especially for small products, aseptic, deep cleansing is important for daily use, personal hygiene and val-
ue retention. The new u-sonic 2 is a valuable accessory and offers optimal cleansing. Powerful ultrasound
at 46 kHz ensures hygienic cleanliness even with clear water.
Operation
1. Fill the cover of the u-sonic 2 to the mark with water and pour it into the stainless steel tub
2. Place the to be cleaned parts into the liquid and close the cover
3. Plug the power supply into an AC power socket
i LED permanent light
4. Briefly touch the sensor button and the ultrasonic cleansing program is starting for 6 min
i LED blink light
5. The device automatically shutdown to stand-by after ultrasonic cleansing process
i LED permanent light
6. Open the cover and remove the cleaned parts
7. Drain the water into a sink after each cleaning process
Maintenance and operation
• Switch off and unplug the appliance before any cleaning and maintenance.
• After ultrasonic cleansing, rinse the cleaned parts under fluent water. Tubes and holes must be well
blown and dried.
• Simple cleansing can be done with pure water. For intensive cleansing a cleansing concentrate or a
splash of mild dish detergent is recommended as an additive.
• You can manually switch the device into stand-by during cleansing process by holding the sensor but
ton for more than 3 seconds.
• We recommend wet wipes for cleaning your u-sonic 2.
2

Publicidad

Tabla de contenido
loading

Tabla de contenido