Instruction For Use; Initial Operation - flow-med vac-clean uv Manual De Instrucciones

EN INSTRUCTION FOR USE

Initial operation

1. Plug the USB cable into a USB power supply unit (5V/1A) and the USB-C plug into the USB-C socket of your vac-clean uv®.
2. Then plug the power supply into a mains socket.
• The vac-clean uv® is charged in approx. 2 hours and ready
for operation for approx. 1.5 hours
! CAUTION: Operation is not possible during the charging process.
Operation with the brush attachment nozzle
3. Insert the brush attachment nozzle into the base attachment of the vac-clean uv®.
4. Press button 1 for at least 2 seconds and the vacuum motor starts
at the strongest suction level (ooo).
• The UV light with 450nm starts automatically with an antimicrobial effect
• Take the previously well-dried hearing aid in your hand and move the brush evenly with light pressure over all sides of the
hearing aid to loosen and vacuum up dried cerumen and dirt
5. when cleaning is finished, switch off the device by pressing button 1
for at least 2 seconds.
Operation with the RIC attachment nozzle
6. Insert the RIC attachment nozzle into the base attachment of the vac-clean uv® and proceed according to points 3 to 5.
• Take the RIC earpiece with domes or earpiece of your hearing aid in your hand and directly join the cavity of the RIC attach
ment nozzle to suck off cerumen and dirt from the openings. If residue remains on the hearing aid, briefly spray cleaning
spray and repeat procedure
i LED 1 lights up red
i LED 1 lights up blue
i LED 1 and LED 2 (ooo) light up
i LED 3 lights up
i LED 1, LED 2 (ooo) and LED 3 turn off
2