Pando E-251 Manual De Instalación página 38

INOXPAN S.L.
POINTS TO BE CONSIDERED:
This model has Internal LED courtesy lighting.
Do not cover the lighting , when you install the false ceiling.(Page 36)
Extraction conduit pipe connection to the extractor hood.
Before the false ceiling is closed, some form of access panel must be installed on the side of the ext
ractor hood where the conduit is connected
The ceiling where the extractor hood is to be installed must be completely flat, with no uneeven
areas of any kind.
For optional operation of the model E-251 ventilation grilles must be installed at ground level to
ensure a continious flow of air.
The maximum distance between the FALSE CEILING and the FLOOR should be no more than
2,40 m.
The width of the hood must always be greater than that of the cooking area. If it is narrower there
is a risk of fumes escaping at the sides. .
This model is only supplied with External, Ceiling and Wall mounted Motors. Thought must there-
fore be given to where the motor will be located, since it must be easily accessible.
Once we know what type of motor we need, we must then consider the maximum distance between
the extractor hood and motor
V2100—4 metres
V1900—15 metres
IMPORTANT: EXTERNAL MOTOR IN FALSE CEILING
The dimensions of the external motor must be taken into account, particulary if it is to be located at
the same level as the false ceiling of the extractor hood. (See dimensions an appendix).
SUPPLIED ACCESSORIES : (these accessories are supplied with the hood):
4 threaded rods of 8mm.
4 washers Ø60mm.
4 wingnuts 8mm.
1 Remote control
1 installation guide.
1 adapter rectangular of 100x260mm for to pipe the conduit by the side;
1* adapter converter from rectangular 100x260mm to circular Ø200mm for to pipe the conduit by
the side.
1 smoke ductwork SEC ( 5m), smoke ductwork of Ø200mm from interior and Ø270 mm from exte-
rior.
(* please note, if you use the adaptor for to pipe to the side air outlet, the height of the hood increase
from 200 to 300 mm, because the adaptor stands out by the upper side of the hood).
V2300—6 metres
V2500—6 metres
8 washers Ø 24mm.
4 wingnuts of 8mm.
4 metalic plugs of 8mm.
1 installation guide
38
EN