Publicidad
Step 12
Step
Carefully turn your unit over onto its front edges. Unfold the
å
BACK (F2) and lay it over your unit.
Make equal margins along all four edges of the BACK (F2). Push
å
on opposite corners of your unit if needed to make it "square".
Fasten the BACK (F2) to your unit using the NAILS (XX).
å
NOTE: Be sure to tap NAILS into the holes that line up over
å
the SHELF (E).
Fasten the TIE PLATES (GG) to the SKIRT (H) and
å
PLINTHS (R2). Use four BLACK 9/16" LARGE
HEAD SCREWS (UU).
These holes must line
up over the SHELF (E).
R2
GG
BLACK 9/16" LARGE HEAD SCREW
(4 used for the TIE PLATES)
www.sauder.com/services
H
R2
UU
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
F2
411843
Caution
NAIL
(50 used in this step)
XX
Page 17
Publicidad
