Using Your Blender - Duronic BL1510 Manual De Instrucciones

Using Your Blender

1) Place the Jug onto the Motor Base. Please make sure that
the Jug is correctly fitted on to the base before operating.
2) Put the ingredients into the jug and then seal with the lid.
3) Plug into a mains socket.
4) Turn the speed control knob from 'O' to 'Mode' or 'Min' and the blender will
be ready to use.
5) Ingredients can be added into the Jug through the Small cup in the lid
6) When you have finished blending, you may take the jug off the motor base.
Please do not remove the jug while the blender is in operation.
Cleaning
1. Before cleaning, unplug the unit from the socket.
2. Do not use any strong or abrasive cleaning agents.
3. A damp cloth should be used to clean the outside of the housing.
4. The jug can be cleaned with warm soapy water.
5. Allow the parts to dry thoroughly before reassembling the unit.
10