Kuppersbusch GKS3811.0ED Instrucciones De Uso página 116

Before performing any regulation, disconnect
the electricity supply to the appliance.
After carrying out any regulation or pre-
regulation operations, any seals must be
replaced by the technician.
The regulation of primary air to our burners is
not necessary.
Regulation of the "Minimum":
It is understood that the aforementioned
regulation must only be carried out with
burners which use G20, while for burners
which use G30 the screw must be blocked
completely.
WARNING:
To adjust the minimum "DUAL" burner first
remove the bushing "E" (fig. 12).
In the case of a "DUAL" burner, the
regulation screw situated inside the post of
the valve regulates the central flame, while
the screw next to the valve regulates the
outer flame.
After making these replacements, the
technician must regulate the burners as
described in paragraph 9, seal any regulation
or pre-regulation organs and apply the labe l
corresponding to the new gas regulation
carried out on the appliance in place of that
previously applied. This label is contained in
the spare nozzle bag.