Ryobi PBC254YES Manual De Utilización página 24

GB
F D E I
SPECIFICATION
(in accordance with NF EN ISO 3744:1995
and NF EN ISO 22868:2005)
Guaranteed sound power level
DESCRIPTION
1. Starter grip
2. Clips
3. Knob
4. Filter
5. Blade guard
6. Tri-arc blade
7. Gear head
8. Screws
9. Throttle trigger
10. Power head shaft
11. Ignition switch
12. Throttle interlock
13. Engine housing
14. Grass deflector
15. Line cut-off blade
16. Cutting line
17. Air filter cover
18. Knob for filter cover
19. Guide recess
20. Button
21. Positioning hole
22. Trimmer attachment
23. Trimmer mode
24. Brush cutter mode
25. Couple
26. Spark plug boot
27. Spark plug
28. Spark Arrester
29. Screw (10-24 x 3/4in)
30. Mounting Bracket
31. Notches
32. Threaded Mounting Plates
33. Locking Tabs
34. Upper Flanger Washer
35. Holding Pin
36. String Head
37. Spool Retainer
38. Drive Connector
39. Wrench (16mm)
40. Cupped Washer
41. Blade Nut
42. Wrench (13mm)
43. Dangerous Cutting Area
44. Direction Of Rotation
45. Best Cutting Area
46. Primer Bulb
47. Choke Lever
P NL S DK N FIN GR HU
115dB(A)
CZ RU RO PL SLO HR TR EST LT
English
48. A Position
49. B Position
50. Spool
51. Eyelets
52. Shaft For String Head
53. Slots For Spool
54. Spring
55. First String
56. Anchor Hole
57. Arrows On Spool
58. Second String
59. Blade Protector
60. Front handle
61. Handle base screw
62. Handle base
63. Bracket
64. Nut
65. Spacer
ASSEMBLY
ATTACHING THE POWER HEAD TO THE
TRIMMER ATTACHMENT (Fig. 1)
WARNING
Never attach or adjust any attachment while
power head is running. Failure to stop the engine
may cause serious personal injury.
The trimmer attachment (22) connects to the power head
by means of a coupler (25) device.
Loosen the knob (3) on the coupler of the power
■
head shaft (10) and remove the end cap from the
attachment.
Push in the button (20) located on the trimmer
■
attachment shaft. Align the button with the guide
recess (19) on the power head coupler and slide the
two shafts together.
Rotate the trimmer attachment shaft until the button
■
locks into the positioning hole (21).
Note: If the button does not release completely in
the positioning hole, the shafts are not locked
into place. Slightly rotate from side to side until the
button is locked into place.
Tighten the knob securely.
■
WARNING
Be certain the knob is fully tightened before
operating equipment; check it periodically for
tightness during use to avoid serious injury.
REMOVING THE ATTACHMENT FROM THE
POWER HEAD
17
LV SK BG