Ryobi PBC254YES Manual De Utilización página 30

GB
F D E I
MAINTENANCE
Store the product in a well-ventilated place that is
■
inaccessible to children.
To Store the Product Long Term
If you do not intend to use the product for more than one
month, follow the storage procedures below.
Follow these steps to store the product long term.
Drain all of the fuel from the tank into a container
■
approved for gasoline.
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORISED SERVICE DEALER.
PROBLEM
Engine will not start.
P NL S DK N FIN GR HU
TROUBLESHOOTING
POSSIBLE CAUSE
1. Switch set to the O (OFF)
position.
2. No spark.
3. No fuel.
4. Flooded engine.
5. Starter cord pulls harder now
than when new.
CZ RU RO PL SLO HR TR EST LT
English
Run the engine until it stops.
■
Clean all foreign material from the product.
■
Store the product in a well-ventilated place that is
■
inaccessible to children.
Note: Keep the product away from corrosive agents
such as garden chemicals and de-icing salts.
Important: Abide by all federal and local regulations
for the safe storage and handling of petrol.
SOLUTION
1. Set switch to the I (ON) position.
2. Remove the spark plug. Reattach the spark
plug cap and lay the spark plug on the metal
cylinder. Pull the starter cord and watch for a
spark at the spark plug tip. If there is no spark,
repeat the test with a new spark plug.
3. Push primer bulb until the bulb is full of fuel.
If the bulb does not fill, the primary fuel delivery
system is blocked. If the primer bulb fills,
the engine may be flooded. (See next item.)
4. Remove the spark plug. Turn the product so
that the spark plug hole is aimed at the ground.
Make sure the choke lever is set to B and pull
the starter cord 10 to 14 times. This clears
excess fuel from the engine. Clean and reinstall
the spark plug. With the trigger fully depressed,
pull the starter cord 3 times. If the engine does
not start, set the choke lever to A and follow
normal starting instructions. If the engine still
fails to start, repeat the procedure with a new
spark plug.
5. Contact an authorized service dealer.
23
LV SK BG