User Instructions - MELICONI AT49 Instrucciones De Empleo

INDOOR AMPLIFIED ANTENNA
FOR DIGITAL TERRESTRIAL SIGNAL
The AT49 indoor amplified antenna receives standard and HD digital terrestrial TV
signals, DAB radio signals, and traditional analogue signals on the UHF and VHF
(band III) bands.
A
If possible, position the antenna near a window or outer wall and at a safe distance
from metal objects, electrical equipment and reinforced concrete walls to ensure optimum
reception.
B
The AT49 is designed to receive digital signals – using a standard and HD digital terrestrial
decoder or a TV with built-in digital tuner – as well as traditional analogue signals.
- Make sure that the TV and the decoder are switched off before making any
connections.
- Connect the Meliconi antenna cable to the socket at the back of the digital terrestrial
decoder or the television (fi gure 1). If the antenna socket on the decoder is of the F
socket type, use an F-plug to IEC-socket adapter (not included).
- Use the AC/DC adapter included in the kit to power up the antenna. Insert the cable
in the antenna power supply input and connect the adapter to the mains power supply
(fi gure 2).
- Switch ON the antenna using the knob located on the side of the antenna and adjust it
to obtain maximum gain.
- Check that the blue LED on the front of the antenna is switched ON. This means that
the antenna is powered up correctly.
- Switch ON the digital terrestrial decoder and the television and select the channel
required. If necessary tune the antenna to suit the TV or decoder.
AT49

USER INSTRUCTIONS

Thank you for choosing MELICONI.
Positioning the antenna
Installation
EN
3