Kohler K-T9474 Guia De Instalacion página 3

Valve
1. Install the Escutcheon
Thread the collar to the valve and hand tighten.
Verify that the trim seal is correctly installed in the escutcheon
hole. The seal is correctly installed when the flat side faces
outward and the tapered side is in.
Remove the backing from the adhesive gasket material. Starting
at the escutcheon drain opening, carefully apply the gasket
material around the back inside edge surface of the escutcheon so
the gasket extends approximately 1/16" (2 mm) beyond the
escutcheon edge.
Trim away any excess gasket material so the escutcheon drain
opening is not blocked.
Carefully slip the escutcheon over the collar and against the
finished wall.
Position the escutcheon so the "Kohler" logo is to the bottom.
Kohler Co.
Finished Wall
Collar
Adhesive
Gasket
Escutcheon
Drain Opening
Trim Seal
3 1012607-2-B