Settings; Aux In Mode; Alarms And Sleep; Alarms - SOUNDMASTER highline IR3000DAB Manual De Instrucciones

8.3

Settings

Scan settings
By default, FM scans stop at any available station. This may result in a poor signal noise ratio (hiss)
from weak stations. To change the scan settings to stop only at stations with good signal strength,
select Menu > Scan setting >Strong stations only?> Yes.
Audio settings
By default, all stereo stations are reproduced in stereo. For weak stations, this may result in a poor
signal-to-noise ratio (hiss). To play weak stations in mono, select Menu > Audio setting >FM weak
reception: Listen in mono only> Yes.

9. Aux in mode

Aux in mode plays audio from an external source such as
an MP3 player.
To play audio with Aux in mode,
1. Turn the volume low on both this unit and, if adjustable, the audio source device.
2. Connect the external audio source to the Aux In 3.5 mm stereo socket.
3. Either press Mode until the display shows AUX or select Menu> Main menu > AUX in.
4. Adjust the volume of this unit ,(and, if necessary, the audio source device) as required.
10.

Alarms and Sleep

As well as a clock/calendar, there are two versatile wake up alarms
with snooze facility, and a sleep function to turn the system off after
set period. Each alarm can be set to start
in a particular mode.
To set the clock/calendar, see Getting started/setup on page 3.

10.1 Alarms

To set or change an alarm, either press Alarm or select Menu > .
Select the alarm number (1 or 2) then configure the
following parameters:
 Enable Off, Daily, Once, Weekends or Weekdays,
 Time: 12:00AM (adjust as necessary)
 Date:01-01-2007(adjust as necessary -this option is usually hidden and only required if "Once" is
selected in the Enable field).
 Mode:: Buzzer, Internet radio, DAB or FM .
 Preset:: Last listened or 1-10.
 Volume:: 0 ~32
To save these settings and set the alarm, scroll down and select Save.
Page 25
IR3000DAB / English Instruction Manual
a