Maintenance; Troubleshooting - Fellowes PS60-2 Manual De Instrucciones

Maintenance

Regular emptying of the basket is important to ensure the smooth operation of the
cutting cylinders. If you can see paper in the basket window (F), turn off and unplug the
shredder, remove the shredder head and empty the basket.
Regular oiling of the confetti-cut model (PS60C-2) is also necessary to ensure proper
performance. If you are running the shredder at or near capacity, we recommend oiling it
monthly. Using Fellowes Powershred Lubricant #35250 or other non-aerosol vegetable-
based oil in a long-nozzle container:
• Apply oil over full width of paper entry (E) with shredder in off [O] position.
• Press control switch to automatic [I] position which will cause shredder to run for
about 2 seconds.
• Press and hold control switch in reverse [R] position for 3-5 seconds.
• Repeat above automatic [I] and reverse [R] sequence three times.
REMINDER: Do not use flammable synthetic oil, petroleum-based products or aerosol
lubricants of any kind in or near the shredder at any time.

Troubleshooting

If you have a problem with your shredder, check the symptoms and remedies below. If you
cannot solve the problem this way, contact Fellowes Customer Service. Do not open
shredder head to attempt repair: It could expose you to serious electric shock and will
void your warranty.
Symptom
Shredder does not start or stops while
shredding.
Red display light (G) turns on and shredder
will not operate.
Shredder squeaks, grinds or runs below
capacity.
Shredder continues to run for a few sec-
onds after shredding has been completed.
Remedy
• Make sure shredder is plugged in and
switch is in automatic [I] position.
• If paper appears to be jammed. Follow
instructions under Operation.
• Check shredder head position (confetti-
cut model only). Follow instructions
under Set-Up.
• Wait 25 minutes for shredder to cool
down before trying again.
• If paper appears to be jammed. Follow
instructions under Operation.
• Check shredder head position (confetti-
cut model only). Follow instructions
under Set-Up.
• Oil cutting cylinders (confetti-cut model
only). Follow instructions under
Maintenance.
• Check window. If paper is visible, empty
basket. Follow instructions under
Maintenance.
No action required. This is a self-cleaning
function.
5