Operation - cecotec HidroBoost 3200 Induction Pro Manual De Instrucciones

ENGLISH
• Unlock trigger and use the pressure washer.
NOTE: It is very important to bleed the gun before using the pressure washer. Squeeze the
trigger to allow any air that is trapped inside of the unit and high-pressure hose to escape.
Continue to squeeze trigger until a steady stream of water comes from the nozzle. (This
process may take up to 2 minutes).

4. OPERATION

This portable pressure washing is a highly specialized multifunctional machine with
exceptionally reliable safety assurance, which may be used to wash and clean cars, bikes and
other outdoor equipment or garden patios, green houses etc.
WARNING: Be aware of the recoil caused by the water jet when the machine is switched on.
NOTE: Pay special attention when cleaning delicate surfaces such as bodywork o wheel rims,
lacquered surfaces, wood, paint, etc.
AUTO ON/OFF
The motor on this pressure washer does not run continuously. It only runs when the trigger
of the spray gun is squeezed. After following the start-up procedures in this manual, turn the
pressure washer ON and squeeze the trigger for activation.
SHUT DOWN
1. Turn off the motor (push switch to the off position).
2. Unplug the unit from the power source.
3. Turn off the water supply.
4. Press the trigger of the gun to depressurize the system.
5. Disconnect the water inlet hose from the pressure washer.
6. Wipe all surfaces of the unit with a damp clean cloth.
7. Engage the gun safety lock.
WARNING:
- Always turn off the unit's motor before turning off the unit's water supply. Serious damage
could occur to the motor if the unit is run without water.
- Never disconnect the high-pressure discharge hose from the machine while the system is
still pressurized. To depressurize the unit, turn off the motor, turn off the water supply and
squeeze the trigger 2-3 times.
ULTRAJET NOZZLES
The pressure washer comes furnished with four spray nozzles. Each nozzle is colour coded
HIDROBOOST 3200 INDUCTION PRO 23