Troubleshooting - cecotec HidroBoost 3200 Induction Pro Manual De Instrucciones

6. TROUBLESHOOTING

PROBLEM
No soap suctions
Smoke comes out
from the device
Not enough
pressure
CAUSE
• The high-pressure
extension hose or hose is
too long
• The pump injector is
clogged
• The soap bottle is clogged
• Overheating, overload or
damaged motor
• Water inlet filter is
clogged
• Air from the hose
connections is entering
the pump
• The nozzle or relief valves
are worn or not the
correct size
SOLUTION
• Remove the high-pressure
extension hose or use a
shorter one (less than 7 m)
• Contact the Technical Support
Service of Cecotec
• Clean the accessory with warm
water
• Replace the accessory
• Turn the device immediately
of and contact the Technical
Support Service of Cecotec
• Clean the water inlet filter
• Check that connections and
locking ring are properly
tightened
• Contact the Technical Support
Service of Cecotec
HIDROBOOST 3200 INDUCTION PRO
ENGLISH
27