Cooper Lighting MD42FLB Instrucciones página 7

MD42FLW_FLB 825-0418.qxd:MD Series 325-1432.qxd
What to do if . . .
Light does not come on
or
Light comes on for only
a few seconds
Light does not shut off
during daytime
Light cycles on and off
Two-year limited warranty
THE FOLLOWING WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER
WARRANTIES, WHETHER EXPRESS, IMPLIED OR STATUTORY INCLUDING,
BUT NOT LIMITED TO, ANY WARRANTY OF MERCHANTABILITY OR
FITNESS FOR ANY PARTICULAR PURPOSE.
Cooper Lighting, LLC ("Cooper Lighting") warrants to customers that, for a
period of two years from the date of purchase, Cooper Lighting's products will
be free from defects in materials and workmanship. The obligation of Cooper
Lighting under this warranty is expressly limited to the provision of replacement
products. This warranty is extended only to the original purchaser of the product.
A purchaser's receipt or other proof of date of original purchase acceptable to
Cooper Lighting. This is required before warranty performance shall be rendered.
This warranty does not apply to Cooper Lighting products that have been
altered or repaired or that have been subjected to neglect, abuse, misuse or
accident (including shipping damages). This warranty does not apply to products
not manufactured by Cooper Lighting which have been supplied, installed,
and/or used in conjunction with Cooper Lighting products. Damage to the
product caused by replacement bulbs or corrosion or discoloration of brass
components are not covered by this warranty.
LIMITATION OF LIABILITY:
IN NO EVENT SHALL COOPER LIGHTING BE LIABLE FOR SPECIAL,
INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES (REGARDLESS
OF THE FORM OF ACTION, WHETHER IN CONTRACT, STRICT LIABILITY,
For assistance, call 1-800-334-6871 or e-mail us at ConsumerProducts@cooperlighting.com
9/3/09
Is there power to the fixture?
• Has the circuit breaker tripped?
• Is the wall switch ON?
Is the bulb screwed in completely?
• Is the bulb good? (Be careful not to over tighten.)
Is the sensor functioning properly?
• Is the sensor locked in place?
• Is light being reflected into the sensor, causing the fixture to
turn off?
Is the wiring to the unit loose?
TURN OFF POWER BEFORE CHECKING.
• Is the unit properly grounded?
Is the light sensor receiving enough light to trigger the switch?
• Perform this simple test. Shine a flashlight into the light
sensor. The fixture should switch off after two minutes (there
is an approximate 2 minute delay). This means the sensor is
not receiving enough light. Install the light shield/reflector to
shine more light onto the photo sensor.
Is the light sensor receiving too much reflected light?
• Perform this simple test. Cover the light sensor with your
finger or a piece of black electrical tape. The fixture should
turn on after a slight delay. This means that extraneous or
reflected light from the fixture is causing the sensor to turn the
unit off. Install the light shield/reflector to block extra light to
the photo sensor.
7
12:59 PM Page 7