hager MD500 Guia De Inicio Rapido página 8

GB
● Programme the installation radio code by pressing the "0" and "1"
push buttons as shown:
Press both keys
Type the series of 10
at the same time
keys corresponding to the
until the light goes
installation radio code
out
0 1
Start customising
Warning: if, during programming, you leave more than 7 seconds
between entries or if you do not press "0" and "1" at the same time
or for long enough, you will quit the programming mode: the red
light flashes, the programming is incorrect. Start the custom ising
procedure again from the beginning.
Allocation of a channel
● Choose the channel required from the following table:
Chanel Channel code Operation
Alert Call
0 0
Silent Alarm
1 0
Audible Signal
1 1
You now have a series of 2 figures corresponding to the channel
code to be entered.
14
Press both keys at the same
time until the light goes out. The
light then comes on again for 5
seconds to indicate successful
programming
...
0 1
End of customising
Triggers the sirens, relay and telephone dialer
interface for 90 secs
Triggers the relay for 90 secs
Triggers the telephone dialer interface
The sirens are not triggered
4 audible beeps on the control panel
The sirens and the telephone dialer interface
are not triggered
● Programme the chanel code by pressing the "0" and "1" push but-
tons as shown:
Press both keys Press both keys
at the same
at the same
time until the
time until the
light goes out light goes out
0 1 0 1
Start customising
Warning: if, during programming, you leave more than 7 seconds
between entries or if you do not press "0" and "1" at the same time
or for long enough, you will quit the programming mode: the red
light flashes, the programming is incorrect. Start the customising
procedure again from the beginning.
● To test the channel code, press the "1" push button for a few
seconds: the medallion light indicator comes on for 2 seconds and
then goes out.
❍ The control panel responds with a series of two-tone audible
signals: "Beeep-bip, beeep-bip, beeep-bip,..." and the light indicator
corresponding to the chosen channel comes on.
Channel Reaction of the control panel in the test mode
Alert Call 2-tone audible message and the Alert light indicator
flashes
Silent Alarm 2-tone audible message and the Silent Alarm light indicator
flashes
Audible Signal 2-tone audible message and the Batteries light indicator
flashes
❍ The telephone dialer responds with a high pitched beep.
If this does not happen, start the medallion customisation proce-
dure again after checking the series of "0" and "1" for the installa-
tion code and channel.
Note for control panels equipped with a radio reception light indi-
cator: although the medallion has the Dual Frequency technology,
it is normal that the radio reception light indicator does not come on
when the medallion is used.
Type the series
Press both keys at the same
of 2 keys
time until the light goes out.
corresponding to
The light then comes on again
the channel code
for 5 seconds to indicate
successful programming.
0
End of customising
GB
1
15