Lutron MK-D Serie Instrucciones Para La Instalación

Installation Instructions
Please Read Before Installing
040440
Rev. A
03/2019
Overview
Color Change Kits allow for changing the color of
the actuating switch assembly of an existing
MA-PRO dimmer.
Important Notes
Environment: Ambient operating temperature:
32 °F to 104 °F (0 °C to 40 °C), 0-90% humidity,
non-condensing. Indoor use only.
Wallplates: Do not paint controls, Color Change Kits,
or wallplates.
Cleaning: To clean, wipe with a clean damp cloth. DO NOT
use any chemical cleaning solutions.
Models Supported: The Color Change Kits may ONLY be
used with the Maestro PRO series dimmers.
Warranty: For warranty information, please see
the enclosed Warranty, or visit www.lutron.com/
TechnicalDocumentLibrary/369-119_Wallbox_Warranty.pdf
Installation
WARNING - Shock hazard. To avoid the risk of
electric shock, locate and lock supply breaker in
the OFF position before proceeding. Failure to do
so could result in death or serious injury.
1. Turn power off at circuit breaker or remove fuse.
2. Remove Wallplate and Adapter. See Figure 1.
Adapter Wallplate
Figure 1
3. Remove existing front actuating switch assembly. Unclip
the existing assembly by pressing in on the clips and
pulling outward one at a time. Start with the bottom
right (1), top right (2), and then the left side (3&4). Pull the
assembly straight out from the control, being careful not
to dislodge the clear plastic frame underneath.
See Figure 2.
Clear Plastic
Frame
2
3
Clips
1
4
Front Accessible
Service Switch (FASS)
Figure 2
Lutron Elec tron ics Co., Inc.
7200 Suter Road
Coopersburg, PA 18036-1299
P/N 040440 Rev. A 03/2019
Lutron Color Change Kits
Compatible with Maestro PRO Dimmers
MK-D, MK-D-5
ENGLISH
MA-PRO
Dimmer
Maestro Color Change Kit
Model Numbers
1 piece Kit - MK-D-XX ¹
5 Piece Kit - MK-D-5-XX ¹
1 "XX" in the model number represents color/finish code.
Note: If the clear plastic frame gets dislodged or lost,
a spare frame is provided with the kit. Follow the
instructions below:
a. Holding the frame with the hook on the left, hook the
frame into the hole next to the center LED pipe.
b. Press firmly on the frame at the hook. When properly
seated, the frame will snap into place. See Figure 3.
4. Install the new actuating switch assembly. Push the
assembly straight onto the control, being careful not to
dislodge the clear plastic frame underneath. Press firmly
on each clip to lock into place. See Figure 3.
LED
pipes
Hook
Figure 3
5. Check control operation. If any of the buttons on the
control feel stiff or do not operate, repeat steps 3 and 4.
6. Install Adapter and Wallplate. See Figure 1.
7. Turn power on at circuit breaker or replace fuse.
8. Check FASS operation. Pull the FASS
in and out several times and ensure that power is
removed and restored to the load.
)Lutron, Lutron, FASS, and Maestro are trademarks or registered trademarks of
Lutron Electronics Co., Inc. in the US and/or other countries.
©2019 Lutron Electronics Co., Inc.