Hydromatic CSS-3D Manual Del Usuario página 3

Description / Installation
INSTALLATION
Piping
Piping must not be smaller than pump discharge.
Electrical
Hazardous voltage. Can shock, burn, or
kill. When installing, operating, or servicing this pump,
follow the safety instructions listed below.
Do not lift pump by the power cord. See "Cord Lift
Warning" on Page 5.
1. DO NOT splice the electrical power cord.
2. DO NOT allow the electrical cord plug to be
submerged.
3. DO NOT use extension cords. They are a fire hazard
and can reduce voltage sufficiently to prevent pump-
ing and/or damage motor.
4. DO NOT handle or service the pump while it is
connected to the power supply.
5. DO NOT remove the grounding prong from the plug
or modify the plug. To protect against electrical shock,
the power cord is a three-wire conductor and includes
a 3-prong grounded plug. Plug the pump into a 3-wire,
HYDROMATIC warrants to the original consumer purchaser ("Purchaser" or "You") of HYDROMATIC Sump Pumps,
Effluent Pumps, Sewage Pumps (other than 2-1/2"), and Package Systems, that they will be free from defects in
material and workmanship for the Warranty Period of 36 months from date of manufacture.
Our warranty will not apply to any product that, in our sole judgement, has been subject to negligence, misapplica-
tion, improper installation, or improper maintenance. Without limiting the foregoing, operating a three phase motor
with single phase power through a phase converter will void the warranty. Note also that
three phase motors must be protected by three-leg, ambient compensated, extra-quick trip overload relays of the
recommended size or the warranty is void.
Your only remedy, and HYDROMATIC's only duty, is that HYDROMATIC repair or replace defective products (at
HYDROMATIC's choice). You must pay all labor and shipping charges associated with this warranty and must
request warranty service through the installing dealer as soon as a problem is discovered. No request for service
will be accepted if received after the Warranty Period has expired. This warranty is not transferable.
EXCEPTIONS: Hydromatic Special Application Pumps, Battery Back-Up Sump Pumps, Filtered Effluent Pumps,
Grinder Pumps, and 2-1/2" Sewage Pumps are warranted for a period of 12 months from date of purchase or
18 months from date of manufacture, whichever comes first.
HYDROMATIC SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL, INCIDENTAL, OR CONTINGENT
DAMAGES WHATSOEVER.
THE FOREGOING WARRANTIES ARE EXCLUSIVE AND IN LIEU OF ALL OTHER EXPRESS AND IMPLIED
WARRANTIES, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE. THE FOREGOING WARRANTIES SHALL NOT EXTEND BEYOND
THE DURATION EXPRESSLY PROVIDED HEREIN.
Some states do not allow the exclusion or limitation of incidental or consequential damages or limitations on the
duration of an implied warranty, so the above limitations or exclusions may not apply to You. This warranty gives You
specific legal rights and You may also have other rights which vary from state to state.
This warranty supersedes and replaces all previous warranty publications.
Phone: 888-957-8677 • Fax: 888-840-7867 • Web Site: http://www.hydromatic.com
LIMITED WARRANTY
HYDROMATIC
740 East 9th Street, Ashland, OH 44805
grounded, grounding-type receptacle. Connect the
pump according to the NEC or CEC and local codes.
The pump is plugged into an automatic float/diaphragm
switch for automatic operation. The pump will run contin-
uously when plugged directly into an electrical outlet.
Connect or wire pump to its own individual branch circuit
with no other outlets or equipment in the circuit. Size
fuses or circuit breakers according to the "Pump, Motor,
Switch and Cord Specifications" chart.
Risk of electrical shock and fire. Be sure
that power supply information (Voltage/ Hertz/Phase) in
this manual matches incoming power supply exactly.
Install pump according to all electrical codes that apply.
NOTICE: Proper ventilation is needed to prevent negative
basin pressure and to provide air within the basin.
The basin should be located at the lowest place in the
basement or area to be drained. Floor drains from other
areas in the basement may be tiled into the basin. Drain
tile around a house foundation may also be tiled into the
basin, effectively removing water and relieving pressure
from this area.
Basin covers are used to exclude refuse from the basin.
3