Hydromatic CSS-3D Manual Del Usuario página 6

Cleaning
TO CLEAN THE IMPELLER
Follow the steps shown below. To reassemble pump,
reverse the sequence.
Risk of electrical shock. Can burn or cause
death.
Before removing the pump from the sump for service,
always disconnect the electrical power source to the
pump. Do not raise, lower or carry the pump by the power
cord. Use the lifting ring provided on the pump.
1. Unplug the Pump.
Unplug the Piggyback Plug
from the Float Switch.
2.
Disconnect the discharge and vent
pipes, and remove basin cover. Be
sure you do not damage the seal ring.
Figure 2: Impeller Cleaning
3. Lift the Pump out of
the Sump Pit by
the Lifting Ring.
4. Remove the Screws that hold the
Base to the Pump Assembly.
Remove the Bottom Plate and
clean out the Impeller.
Pump Assembly
Impeller
location
Bottom Plate
Base
Base
Screws
6