Troubleshooting - Gardena HandyMower 22/18V P4A Instrucciones De Empleo

Ocultar thumbs Ver también para HandyMower 22/18V P4A:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 47
Cutting performance and battery charge:
The lawn area which can be cut on each battery charge depends on
several factors such as moisture, grass density and cutting height.
In order to ensure an optimal use of space, do not turn the mower on
and off too frequently as this severely reduces the battery running time.
The cutting performance for each battery charge can be ideally utilised
by increasing the cutting height and frequent mowing.
Mulching:
The specially shaped blade ensures optimum cutting and mulching results.
The blades of grass are not simply cut off, but cut into small particles
which fall onto the ground between the blades of grass, thus reducing
the drying out of the lawn. Grass cuttings do not have to be collected
or disposed of and are a natural fertiliser.
The best mulching result is achieved when 1/3 of the grass height is cut
(e. g. from 60 mm to 40 mm).
The maximum area of 50 m² can only be achieved with optimum conditions.
4. MAINTENANCE
DANGER! Risk of injury!
Cut injury when the product starts accidentally.
v Wait for the blade to stop, remove the safety key and use
gloves before you maintain the product.
To clean the mower:
DANGER! Risk of injury!
Risk of injury and risk of damage to the product.
v Do not clean the product with water or with a water jet
(in particular high-pressure water jet).
v Do not clean with chemicals including petrol or solvents.
Some can destroy critical plastic parts.
To clean the underside of the mower [ Fig. M1 ]:
The underside is easiest to clean after you mowed.
1. Lay the mower on its side carefully.
2. Clean the underside and the blade
scraper
(10)
(do not use sharp objects).
To clean the overside of the mower:
v Clean the overside with a damp cloth.
To clean the battery and the battery charger:
Make sure that the surface and the contacts of the battery and the battery
charger always are clean and dry before you connect the battery charger.
Do not use running water.
v Battery charger: Clean the contacts and the plastic parts with a soft
and dry cloth.
v Battery: Occasionally clean the ventilation slots and the terminals on
the battery using a soft brush that is clean and dry.
5. STORAGE
To put into storage [ Fig. S1 ]:
The product must be stored away from children.
1. Turn the safety key to position
2. Remove the battery.
3. Charge the battery.
4. Clean the mower, the battery and the battery charger
(see 4. MAINTENANCE).
5. To save space, the mower can be suspended from the tube in the
GARDENA Tool Holder Art. 3501 / 3503 (The mower must not
be suspended from the handle).
6. Store the mower, the battery and the battery charger in a dry,
enclosed and frost-free place.
Disposal:
(in accordance with RL2012/19/EC)
The product must not be disposed of to normal household
waste. It must be disposed of in line with local environmental
regulations.
12
14620-20.960.01.indd 12
(9)
with a brush and the enclosed
and remove it.
IMPORTANT!
v Dispose of the product through or via your municipal recycling
collection centre.
Disposal of the battery:
The GARDENA battery contains lithium-ion cells that
should not be disposed of with normal household waste
at the end of its life.
Li-ion
IMPORTANT!
v Dispose of the batteries through or via your municipal recycling
collection centre.
1. Discharge the lithium-ion cells completely (contact the GARDENA
Service).
2. Protect the contacts on the lithium-ion cells against short circuits.
3. Dispose of the lithium-ion cells properly.

6. TROUBLESHOOTING

DANGER! Risk of injury!
Cut injury when the product starts accidentally.
v Wait for the blade to stop, remove the safety key and use
gloves before you troubleshoot the product.
To replace the blade:
DANGER! Risk of injury!
Cut injury when the blade turns and it is damaged, bent,
out of balance or has chipped edges.
v Do not use the mower when the blade is damaged, bent,
out of balance or has chipped edges.
v Do not regrind the blade.
The GARDENA spare parts are available from your GARDENA dealer or
from the GARDENA Service.
Only use an original GARDENA blade:
• GARDENA Replacement blade
v Let the blade be replaced by the GARDENA Service or a specialist
dealer authorised by GARDENA.
Problem
Possible Cause
Engine is jammed and
Motor is blocked.
makes a noise
Cutting height is too low.
Loud noises, the mower
Screws on engine, its fixing
is rattling
or on the mower chasing are
loose.
Mower runs unevenly or
Blade is damaged / worn
vibrates strongly
or the blade mounting is
released.
Blade is very dirty.
Lawn is not cleanly mowed
Blade is blunt or damaged.
Cutting height is too low.
Mower does not start
Battery is empty.
or stops.
(L1)
LED
is flashing green
[ Fig. O4 ]
Mower does not start
Battery temperature is outside
or stops.
the permissible temperature
(Wp)
Error-LED
is illuminated
range.
red [ Fig. O4 ]
There are drops of water or
moisture between the battery
contacts on the mower.
Motor is blocked.
Art. 4105
Remedy
v Remove the obstacle.
Start again.
v Raise the cutting height.
v Let the screws be tightened
by an authorised specialist
dealer or the GARDENA
Service.
v Let the blade be tightened
or replaced by an authorised
specialist dealer or the
GARDENA Service.
v Clean the mower
(see 4. MAINTENANCE).
If this does not rectify
the problem, contact the
GARDENA Service.
v Let the blade be replaced by
the GARDENA Service.
v Raise the cutting height.
v Charge the battery.
v Wait until the battery tem-
perature is between
0 °C – + 45 °C again.
v Remove the water drops /
moisture with a dry cloth.
v Remove the obstacle.
Start again.
04.09.20 09:24

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

14620

Tabla de contenido