Safety In The Workplace; Electrical Safety; General Safety Instructions - Würth ASN 5090 HF Traducción Del Manual De Instrucciones De Servicio Original

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 41
Format of safety instructions
Type and source of the danger!
Consequences of non-observance
Â
Danger prevention measure
¾

Safety in the workplace

Do not operate the tool in areas where there is a
risk of explosion.
Electric power tools generate sparks that could
Â
ignite dust or fumes.
Keep the tool out of the reach of children and
never leave it unattended. When not in use,
keep the tool in a safe place out of the reach of
unauthorised persons.

Electrical safety

The device must not be operated in a wet or
damp environment. Do not expose the device to
rain.
If water penetrates into the electrical device, the
Â
risk of an electric shock is increased.
Self and personnel protection
Persons less than 18 years old must not use the
device. Excepted from this are young persons of
16 and over who are working under supervision
within the scope of their vocational training.
Always remain alert and take the utmost care
when working.
Do not use the tool if you are tired or under the
influence of drugs, alcohol or medicines.
One moment of inattention can result in severe
Â
injuries.
Always wear safety glasses and ear defenders.
Wear stout shoes and a safety helmet.
The wearing of personal protective equipment,
Â
such as non-slip safety shoes, safety helmet or
ear defenders, reduces the risk of injury.
Never carry the tool with your finger on the
trigger.
If when doing so the non-mar tip is accidently
Â
pressed, firing can be unintentionally triggered
and cause severe injuries.
Safety Instructions
DANGER!
Ensure that you can always maintain a safe
standing position and maintain your balance at
all times.
By doing so, you are better able to control the
Â
tool in unexpected situations.
Never point the tool towards any part of your
body, towards yourself or towards other persons.
Battery hazards
The following items must be observed if the
device is damaged:
• ensure that leaking fluids cannot enter the
ground or groundwater
• if a contamination has already occurred, it must
be removed in accordance with applicable
national regulations
Protect the device against heat.
Fire hazard is present if the battery overheats.
Â
If a battery is defective, fluid may leak from the
device.
• Avoid contact with the liquid.
• Clean and check the parts that came into con-
tact with the liquid
If the battery is damaged or used improperly,
hazardous vapours may exit and cause irritation
to the airway.
• Provide for fresh-air supply and consult a physi-
cian in case of complications.

General safety instructions

Secure yourself and the device when working on
high or inclined working surfaces.
Always visually check the device for damage
before initial use and after transport. Ensure any
damage is repaired by trained service personnel
prior to initial use.
Use only genuine Würth accessories and
spare parts.
15

Publicidad

Tabla de contenido
loading

Tabla de contenido