Würth ASN 5090 HF Traducción Del Manual De Instrucciones De Servicio Original página 18

Driving frequency (Fig. I)
▸
Turn selector switch [3] to position  to reduce
the driving frequency.
▸
Turn selector switch [3] to position  to
increase the driving frequency.
Note!
The operating life of the battery is
reduced when a high driving frequency
is selected.
Driving energy (Fig. I)
The device is equipped with a selector switch [8] on
the underside for two driving energy levels.
▸
Set the switch to level 1 for shorter nails.
Symbol of a short nail is shown.
3
▸
Set the switch to level 2 for longer nails and more
demanding applications.
Symbol of a long nail is shown.
3
Attention!
Excessive wear or even destruction of the device
possible!
Driving in nails below 71 mm in length with
Â
level 2 will result in excessive wear. Failures can
occur more quickly.
Select the driving energy according to the nail
¾
length.
Example:
Level Advantage
Sufficient ener-
2 gy to drive in
longer nails
Longer service
1 life, longer
battery life
18
Application Nail length
Nailing work
Rails
71 - 90 mm
Ceiling beams
Half-timber
work
Floor coverings
Panels
50 –70 mm
Fences
Shuttering
Wooden laths
Operation
Safety interlock (Fig. II)
The device is equipped with a safety interlock [4].
▸
Push the safety interlock to the right to prevent
triggering.
The trigger is locked and the power is diverted to
3
the motor.
The device becomes fully functional again once
3
the safety interlock is pushed to the left.
Risk of severe injuries.
Unintentional starting can result in
Â
injuries.
Switch off the device and remove
¾
the battery before any adjustment or
any removal/fitting of accessories.
Always hold the device firmly
¾
and be prepared for any sudden
reaction.
Preparation
▸
Remove the battery [9] from the device and check
that the safety interlock has been activated.
▸
Remove all nails from the magazine [12].
▸
Check that the contact stop [13] moves freely.
▸
Insert a nail strip into the magazine.
▸
Reinsert the battery.
Risk of severe injuries.
Do not use the device if the contact
¾
stop or the cocking slide cannot
move freely.
WARNING!
WARNING!