Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1
INSTALLATION INSTRUCTIONS FOR
The SLIDE BAR (1) works best when secured to the wall studs or cross brace using the WOOD SCREWS. If a mounting
into the studs is not possible, use appropriate wall fasteners provided to secure the installation.
Mark a vertical center line in the location you wish to install the SLIDE BAR (1). NOTE: The height from the finished floor
is optional. See rough-in drawing for suggested dimensions.
Determine desired height from the nished oor to the lower support and mark a horizontal center line. Measure up
625mm (24-5/8") and mark another horizontal center line marking the location of the two mounting holes to be drilled. Fig. A.
Using 15/64" diameter drill. Drill two mounting holes 1-1/4" max. deep. Fig. A.
Install the two ANCHORS (2) provided into the mounting holes. Use a hammer to lightly tap ANCHORS (2) into place.
Make sure they are installed ush against the nished wall. Fig. B.
Place the MOUNTING BRACKET (3) over the ANCHORS (2) and secure the MOUNTING BRACKET (3) with the
SCREWS (4) provided. The top MOUNTING BRACKET (3) should have the slot facing up and lower MOUNTING
BRACKET (3) should have the slot facing down. See illustration. Fig. B.
Align and install the SLIDE BAR (1) onto the MOUNTING BRACKETS (3). Important: Make sure the larger diameter
hole in the HOLDER END (5) is on top. Rotate HOLDER END (5) 180˚ if it is not. If SLIDE BAR (1) cannot be installed
loosen MOUNTING BRACKETS (3) adjust, tighten a nd re-install SLIDE BAR (1). Fig. B.
Hold SLIDE BAR (1) against nished wall. Tighten the four SET SCREWS (6) with the HEX WRENCH (7) supplied with
SLIDE BAR (1). Fig. B.
Check operation of SLIDE BAR (1) by rotating HAND SHOWER HOLDER KNOB (8) and moving HAND SHOWER HOLDER (9)
up and down. Rotate KNOB (8) back to lock HAND SHOWER HOLDER (9). Fig. B.
625mm
(24-5/8")
C/L
FINISHED
FLOOR
1660.230
Fig. A
LEVEL
OPTIONAL TO FINISHED FLOOR
USUALLY BETWEEN
915mm
TO
1525mm
(36")
(60")
2
SLOT UP
4
Fig. B
3
6
1
C/L
8
2
3
SLOT DOWN
4
6
7
5
LARGE DIAMETER
HOLE ON TOP
9
M965259 REV. 1.4 (8/18)
Publicidad
Tabla de contenido
