American Standard 1660 Serie Instrucciones De Instalación página 3

1
INSTALLATION INSTRUCTIONS FOR
The SLIDE BAR (1) works best when secured to the wall studs or cross brace using the WOOD SCREWS. If a mounting
into the studs is not possible, use appropriate wall fasteners provided to secure the installation.
Mark a vertical center line in the location you wish to install the SLIDE BAR (1). NOTE: The height from the finished floor
is optional. See rough-in drawing for suggested dimensions.
Determine desired height from the nished oor to the lower support and mark a horizontal center line. Measure up
625mm (24-5/8") and mark another horizontal center line marking the location of the two mounting holes to be drilled. Fig. A.
Using 15/64" diameter drill. Drill two mounting holes 1-1/4" max. deep. Fig. A.
Install the two ANCHORS (2) provided into the mounting holes. Use a hammer to lightly tap ANCHORS (2) into place.
Make sure they are installed ush against the nished wall. Fig. B.
Place the MOUNTING POSTS (3) over the ANCHORS (2) and secure with SCREWS (4) provided. Fig. B.
Slide ROUND ESCUTCHEON (11) onto SLIDE BAR (1). Fig. C.
Align and install the SLIDE BAR (1) onto the MOUNTING POSTS (3). Important: Make sure the larger diameter
hole in the SPRAY HOLDER END (5) is on top. Rotate HOLDER END (5) 180˚ if it is not. Fig. C.
Hold SLIDE BAR (1) against nished wall. Tighten the two SET SCREWS (6) with the HEX WRENCH (7) supplied with
SLIDE BAR (1). Hold the Escutcheon (11) ush against the nished wall and tighten SET SCREW (10) with HEX
WRENCH (7). Fig. C.
Check operation of SLIDE BAR (1) by rotating HAND SHOWER HOLDER KNOB (8) and moving SLIDER (9) up and down.
Rotate KNOB back to lock SLIDER (9). Fig. C.
Fig. A
625mm
LEVEL
(24-5/8")
C/L
OPTIONAL TO FINISHED FLOOR
USUALLY BETWEEN
915mm
(36")
FINISHED
FLOOR
1660.330
C/L
1525mm
TO
(60")
3
2
4
3
Fig. B
2
4
3
10
7
11
6
1
Fig. C
8
9
3
6
7
M965259 REV. 1.4 (8/18)
5
LARGE DIAMETER
HOLE ON TOP