Kohler K-16137-4 Manual Del Usuario página 4

1/2" N.P.T.
Finished
Nipples
Wall
Wall Bracket
Sleeve
Outlet Port
1-3/8"
(3.5 cm)
Inlet Port
Vacuum
Breaker Body
Socket Head
Screws
2. Install the Vacuum Breaker
NOTE: To protect the finish, do not install the shroud and cover
until all rough installation and construction is complete.
Place the wall bracket over the nipples.
Insert the sleeves into the wall bracket and thread onto the
nipples.
Tighten the sleeves using a Kohler seat wrench #21261 or 7/16"
square bar.
Slide the vacuum breaker inlet/output ports into the sleeves in
the wall bracket and secure with two socket head screws using a
5/32" hex wrench.
Place the shroud over the vacuum breaker with the cut-out over
the input/output ports and the threaded pin through the hole at
the top of the shroud.
Thread the cover onto the threaded pin until hand-tight.
116373-2-AB
Cover
Slot
Shroud
Threaded Pin
4 Kohler Co.