OVE ANTIGUA SP 32 Manual Del Usuario página 11

GLASS PANEL AND SUPPORT BAR INSTALLATION
1-2. Mark the positions of holes of the sliding door guide (Q) and the side panel clamp (W).
3-4. Place the support bar (F) in order to align the bracket (G) in front of the the fixed panel's hole. Position the
support bar in so that distance A and B are the same. Mark the outline of the 2 support bar's anchors (D) on the wall.
5-6. Completely remove the support bar (F) and the fixed panel (C).
7. Drill a pilot hole for the sliding door guide (Q) and the side panel clamp (W) using a ø3mm (1/8in) drill bit.
8. Install the sliding door guide (Q) with the screw (CC) and the cap (HH).
9. Install the side panel clamp (W) with the screw (II).
1
Q
3
B
A
G
F
C
5
F
C
G
7
Φ3mm
1/8in
8
HH
CC
Helpful Hint
Add a drop of
silicone in the
holes before
Q
inserting the
screws
11
2
W
4
B
A
C
D
F
6
B
C
9
II
W