THOMSON MIC400BT Manual De Instrucciones página 35

FM radio
Carefully extend the telescopic aerial in full. You can programme up to 50 pre-set radio
stations (FM).
Automatic tuning
1. Press the SOURCE button to select "RADIO" mode.
2. Hold the button down so that the radio scans the frequencies and stops automatically
when it finds a station with a sufficient signal strength (50 pre-set stations).
3. The screen updates after a few seconds. The screen shows the station frequency.
4. Press MEM to display the pre-set radio stations.
5. Press MEM+ or MEM- to listen to the radio.
6. To find other stations, hold the
7. To scan the FM band in reverse (high frequencies to low frequencies), press the
and hold it down for 2 seconds.
Manual tuning
1. Press the SOURCE button on the main appliance to select RADIO mode.
2. Press or
button, the frequency increases or reduces by 50 kHz.
3. Once you have found a frequency you want to save, press the MEM button on the remote
control. "P01" is displayed on the screen; press MEM+/MEM- until the memory number you
want is displayed on the screen. Press MEM again to confirm and save the current station.
4. Press MEM+ or MEM- to display or listen to the radio.
(Comment: once the end of the frequency band is reached, the radio starts to search for
frequencies again, starting at the other end of the band. If no station is found, ensure that
the aerial is fully extended and test the reception by carrying out automatic tuning again in a
different location).
Bluetooth Mode
You need to carry out several steps to connect your mobile phone:
1. Activate the Bluetooth on your mobile phone (ensure you refer to the instructions for your
telephone).
button down as before.
to reach a frequency. Every time you press the frequency adjustment
- EN 35 -
button