Faucet Installation - sanindusa TUBE 531738111 Instrucciones De Montaje Y Manutención

//FAUCET INSTALLATION

531738111
Electronic tap without box
EMPLOYED ON REMOVABLE RIGID PANELS OR BACK
ACCESS OF 5MM MINIMUM THICKNESS AND NOT
SUPERIOR TO 35mm.
1º
step
remove all mounting hardware
1 – Shut off water supply. Cut a hole at the place you
want to install the spout of the tap. Keep a distance of
not less than 300 mm between the botton of the
washbasin and the spout to avoid reflection problems.
2 – Insert the flexible hose, the cable and the base
through the wall.
3 – Fix the base, behind the wall with the hexagonal nut
and the disk.
4 – Insert the wall rosette through the base.
5 – Fix the tubular spout by inserting the nipple into the
base. Make sure that this area is clean before
proceeding. Scure the screw with the allen key. Make
sure that the aerator at the spout will be installed facing
the washbasin.