sanindusa TUBE 531738111 Instrucciones De Montaje Y Manutención página 58

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

//SETTINGS ADJUSTMENT
Adjusting other settings with the remote control:
Short flow time (only in flow meters) :
This function determines the water flushing time once the user leaves
the W.C. after being present in front of the sensor for less than a
minute. If required, the short flow time can be modified as follows:
Press the one wave button. Wait until a quick flashing of the red light
of the sensor eye is perceived. Then, press (+) to increase the flow
time and (–) to reduce it.
Full flow time (only in flow meters) :
This function determines the water flushing time once the user leaves the W.C.
after being present in front of the sensor for a minute or more.
Press the two waves button. Wait until a quick flashing of the red light of the
sensor eye is perceived. Then, press (+) to increase the flow time and (–) to
reduce it.
Delay in time:
The delay in time prevents unwanted activations. This can occur, for example, if a
person passes close to the W.C. without the intention of using. Due to the delay in
setting, the sensor will only activate the system if the user is detected for the
preset amount of seconds. If required, the delay in time can be modified as
follows: press the IN button. Wait until a quick flashing of the red light of the
sensor eye is perceived. Then, press (+) to increase the delay in time and (–) to
reduce it.
Delay out time:
This function allows modifying the time the flush valve will deliver water after
the user leaves the W.C. In this case, a delay out time close to 0 will not give the
user the possibility to be away from the sanitary. An increased delay out time will
make the user experience more comfortable, but high traffic of users should be
taken into consideration. If required, the delay out time can be modified as
follows: Press the OUT button. Wait until a quick flashing of the red light at the
sensor eye is perceived. Then, press (+) to increase the delay out time and (–) to
reduce it.
58
59
//

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Tube 531739111

Tabla de contenido