Set end time
You can set the time at which the cooking process is to be ended here.
1. Tap
. Use the Smart Slider or tap the "+/-" symbol to set the end time in hours. Tap
to set the end time in minutes. When you have finished setting, tap
2. If you set the end time, you must also set the cooking time. For information on how to set the
cooking time, refer to the section "Cooking with the oven".
3. For example, if you set the end time to 10 o'clock and the cooking time to 1 hour, the oven will
heat up at 9 o'clock and be ready at 10 o'clock.
Changes while cooking
When the appliance is switched on, you can change the operating mode and temperature using the
oven function control or the Smart Slider. If no further action is taken after the change for 6 seconds,
the oven will accept the change.
If you want to change the cooking time while cooking, tap on
Slider or the "+/-" symbol. If no further action is taken after the change for 6 seconds, the oven will
accept the change. You cannot make any changes during a cooking process with a specified end
time and during automatic programmes.
If you want to cancel the cooking process, tap
Notes
Changing the operating modes/temperature/remaining cooking time can have a number of negative
effects on the cooking result. We recommend that you avoid doing this – unless you are an
experienced cook.
Caution!
After switching on the appliance, it will become very hot, especially inside. Never touch the inner
surfaces of the appliance or the heating elements. Use oven gloves to remove accessories or
ovenware from the cooking chamber and let the appliance cool down. Keep children at a safe distance
to avoid burns.
Timer
Tap
to use the timer function. When the set time is up, the oven will signal this with a beep. The
first time you tap the
minutes. Tap the
symbol once more to end the setting process. You can set the timer before and
during cooking, but if you select the function and temperature, the timer will not be available.
symbol, the hours are set. Then tap the
and change it using the Smart
.
symbol again to set the
12
again
to save the setting.