Technical Data - YATO YT-09676 Manual Original

CHARACTERISTICS OF TOOL
Pneumatic grinder is powered with a stream of compressed air at the appropriate pressure. By using the and cutting and grinding wheels it is possible to cut and grind various
materials. Correct, reliable, and safe operation of the tool is dependent on its proper use, therefore:
Prior to working with the tool, you should read all the instruction and keep it around.
For any damage or injuries caused by the tool misuse, failure to comply with safety regulations and instructions in this manual, the supplier is not responsible. The tool misuse
causes also the loss of user rights to the guarantee and warranty. as it would be a non-compliance with the contract.
EQUIPMENT
The grinder is equipped with a coupling to attach it to the pneumatic system. The device is also equipped with the keys, which allow you to attach an accessory in the holder

TECHNICAL DATA

Parameter
Catalog number
Weight
The diameter of the air connection (PT)
The diameter of the air inlet hose (internal)
Rotations
Diameter of tool holder
Maximum diameter of accessories
Maximum operation pressure:
Required air fl ow (at 6.2 bar)
Sound pressure (ENISO 15744)
Sound power (ISO 15744)
Vibration (EN 28662-1)
GENERAL SAFETY CONDITIONS
WARNING! When you are working with a pneumatic tool, we recommend that you always comply with the basic principles of occupational safety, including the principles pre-
sented below, in order to reduce the risk of fi re, electric shock and to prevent injuries.
Prior to working with the tool, you should read all the instruction and keep it around.
ATTENTION! Read all the instructions below. Failure to comply with them can lead to electrical shock, fi re or personal injury. The concept of "pneumatic tool", which is used in
the instructions, refers to all tools, which are driven by a stream of air compressed at the right pressure.
COMPLY WITH THE FOLLOWING INSTRUCTIONS
General safety conditions
Before starting the installation, work, repair, maintenance and changing of accessories, or when you are working near pneumatic tool, because of many risks, you should read
and understand the safety instructions. if the above mentioned steps are not taken, it may result in serious injury. Installation, adjustment and installation of pneumatic tools
may be performed only by qualifi ed and trained staff . Do not modify the pneumatic tool. Modifi cations can reduce the effi ciency and level of security, and increase the risk for
a tool operator. Do not discard the safety instructions, you must pass them to the tool operator. Do not use pneumatic tool, when it is damaged. The tool should be subject to
periodic inspections for visibility of the data required by ISO 11148. The employer/user should contact the manufacturer for replacement of a rating plate whenever it is necessary.
Hazards associated with moving parts
Damage to the workpiece, accessories or even the inserted tool can cause the ejection of parts at high speed. Always use the eye protection which is impact-resistant. Degree
of protection should be selected depending on the work to be done. You should make sure, that the workpiece is securely clamped. You should regularly check whether the
rotation speed is not higher than the values shown on the rating plate. Control should be performed without mounted inserted tool, and in accordance with the manufacturer's
O R I G I N A L
GB
Unit
[kg]
[''] / [mm]
[''] / [mm]
[min -1 ]
[mm]
[mm]
[MPa]
[l/min]
[dB(A)]
[dB(A)]
[m/s 2 ]
I N S T R U C T I O N S
Value
YT-09676
0,48
1/4 / 6,3
3/8 / 10
20 000
6
50
0,63
113
92,0 ± 3,0
103,0 ± 3,0
1,4 ± 1,5
11