PROPERTIES OF THE TOOL
The angular grinder is an electric tool designed for grinding and cutting metals as well as mineral construction materials, such as
bricks, natural and artifi cial stone, concrete, glaze, etc. with abrasive disks and grinding wheels selected for the given material.
The tool must not be used for processing other materials than those mentioned above, e.g. for grinding and cutting wood or pol-
ishing. A correct, reliable and safe functioning of the grinder depends on its proper use, so:
Before you proceed to operate the grinder, read the manual thoroughly and keep it.
Always use protective goggles!
Do not use grinding wheels whose maximum acceptable tangential velocity is lower than 80 m/s!
Do not use grinding wheels whose maximum acceptable rotational speed is lower than the rotational speed of the grinder.
The supplier will not be held responsible for any damage resulting from the safety regulations and the recommendations indicated
hereby not being observed.
EQUIPMENT
The product is supplied in a complete state but it requires some installation activities before starting its operation. The product is
supplied with the battery charger and charging station (charger). abrasive disk guard, the wrench for mounting the grinding wheel
and the auxiliary handle. The equipment does not include grinding wheels.
TECHNICAL PARAMETERS
Parameter
Catalog number
Mains voltage
Rated revs
Diameter of the abrasive disk
Diameter of the abrasive disk hole
Spindle tip
Weight
Noise level
- accustic pressure LpA ± KpA
- power L
± K
wA
Vibration level
± K
ah, AG
Insulation class
Degree of protection
Type of the battery
Capacity of the battery*
Charger*
Input voltage
Mains frequency
Output voltage
Input current
Rated power
Time of charging**
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fi re or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain infl ammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fi re in case of contact with infl ammable gases or vapours.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
O R I G I N A L
GB
Unit
[V]
[min
]
-1
[mm]
[mm]
[kg]
[dB (A)]
[dB (A)]
[m/s
]
2
[Ah]
[V]
[Hz]
[V]
[A]
[W]
[h]
I N S T R U C T I O N S
Value
YT-82829
18 DC
2000 - 9000
125
22,2
M14
1,6
82,6 ± 3,0
93,6 ± 3,0
6,2 ± 1,5 / 5,8 ± 1,5
III
IPX0
Li-Ion
3
220 - 240
50 / 60
21 DC
2,4
60
1,5
13