Implements Coupling; Rotary Hoe - NIBBI BRIK 1 Uso Y Mantenimiento

IMPLEMENTS COUPLING

The machine is equipped with a quick
implement connection. Before mounting
the implement, make sure that the P.T.O.
engagement lever is in idle position.
When connecting or disconnecting the
implements, it is necessary to pull the
knob upwards and turn it through 90°,
engage the implement in the connection
sleeve and bring the knob back to its
original position. Make sure that the
shutter has gone into the stop hole.

ROTARY HOE

Technical characteristics:
Rotary Hoe speed: 310 rev/min., with
engine at 3600 rev/min.
Hood width:50-40 cm and 60-65 cm.
N° blades: 16
Working depth adjustment
In order to vary the working depth,
adjust the central hoe's inclination by
removing fixing screw (2) and shifting
the perforated rod (3) until it meets a new
hole. When working with hard terrain,
to prevent the machine from bounding
forwards, adjust the central knife by
moving it downwards into the last hole.
MAINTENANCE
ATTENTION - Maintenance operations
must be carried out with machine at
standstill and engine switched off.
Fig. 18A
Fig. 19A
Each time the Rotary Hoe is used check
that:
1. The bolt is turned until it trips into
gripped position.
2. The the blades' nuts and fixing screws
are well tightened.
3. The oil of the bevel pair gear box is
at correct level, i.e. almost full.
ATTENTION - When changing the
blades ensure that they are fitted in
the same way.
Fig 20a
39