Technical Information; Legal Requirements; Installing The Oven; Installation - Gorenje CB8900E Manual De Mantenimiento E Instalación

Technical Information

The item that you have bought meets the
European directives on electrical material
safety (73/23/CEE) and electromagnetic com-
patibility (89/336/CEE).

Installation

This information is intended for the installer,
as the person responsible for assembly and
electrical connection. If you install the oven
yourself, the manufacturer will not be held
responsible for any possible damage.
Installation must only be performed by a fully
qualified electrician who must ensure
regulations laid down for installation are
observed.
Before Installation. Comments
• To unpack the oven, pull the tab located on
the lower part of the box.
• A niche is required in the kitchen unit as
per the dimensions shown on the figure,
providing a minimum depth of 580 mm.
(See figures 1 and 2 describing oven fitting
on the page 38).
• To fit multifunction ovens in their locations,
the back part of the unit corresponding to
the shaded area of figure 3, must not have
any projections (reinforcements, pipes,
sockets, etc). (See the page 38).
• The adhesive used for the plastic covering
of kitchen furniture must be able to
withstand temperatures up to 85ºC.
12
Electrical Connection.

Legal Requirements

The installer must check that:
• The voltage and cycles of the mains supply
correspond to that indicated on the rating
plate.
• The electrical installation can stand the
maximum power indicated on the rating
plate.
• To connect the oven to the electrical circuit,
the installer must use a T150 type supply
cable.
• The connection diagram is shown in the
following figure:
230 V 1
N
L
2
3 x 1,5mm
• The electrical connection has adequate
earthing in accordance with regulations in
force.
• The connection must be carried out with an
omnipolar switch, of an adequate size for
the current drawn. There must be a
minimum aperture between contacts of 3
mm to enable disconnection in the case of
emergency, cleaning or bulb exchange.
Under no circumstances must the earth
wire pass through this switch.
• This switch may be replaced with a plug,
which must always be accessible in normal
working conditions.
After connecting the electricity, check that all
the electrical parts of the oven are working.

Installing the Oven

For all ovens and after carrying out the
electrical connection,
1 Insert the oven in the kitchen unit, making
sure the power lead is not trapped or in
contact with hot parts of the oven.
2 Fix the oven to the unit by means of the 2
screws supplied via the holes that can be
seen when the door is opened.
3 Check that the oven housing is not in contact
with the sides of the unit and that there is at
least 2 mm separating the neighbouring
units.
13