HoMedics envira Scape WF-SBWL Manual De Instrucciones E Información De Garantía página 4

Maintenance:
1. To keep water clean:
Periodically change water and clean the product according to the water
condition. Keeping the water clean prevents the water from becoming
sticky and forming micro-organisms. We recommend distilled water to
prevent mineral build-up.
2. To clean off hard water deposits on the base:
Use a mixture of vinegar and water to clean and remove any mineral
build-up on the base and pump.
3. Keeping the water at an optimum level:
Add water periodically to keep water level at an optimum level and to
avoid shortening the life of the pump. Note: Never let the pump run dry.
4. Fountain storage:
Unplug the fountain from the electrical outlet, empty the water, and
store in a dry, cool place.
5
Troubleshooting:
Caution:
All servicing of this
1. If the pump fails to operate, check the following:
fountain must be
Check the circuit breaker, or try a different outlet to
performed by make sure the pump is getting electrical power.
authorized Note: Always disconnect from electrical
outlet before handling the pump.
HoMedics
2. If the pump gurgles, spews, or "burps":
service
Check the water level to make sure the pump has
personnel only.
enough water to function.
3. Obtaining a desired water level:
Check the water level daily the first week to
measure the rate of evaporation; refill with water
as needed.
4. If water is splashing outside the fountain:
Adjust the flow control valve to a lower setting on
the pump.
READ CAREFULLY AND KEEP FOR
FUTURE REFERENCE
Figure 2
Attention:
In order to get best
results, please
operate pump
completely
submerged.
Keep the water level
above the
minimum water level
ALL THE TIME.
7
Minimum Water Level
Flow Control Valve
(+) faster water
output
(-) slower water
output