Maintenance; Daily Inspection; Cleaning; Dispose Of The Psc - Bosch PSC 2 Manual Original

5.

Maintenance

This Section describes the maintenance work which
can be performed by the user.
5.1

Daily inspection

The following points must be checked on a daily basis:
Test
Is the lens cover clean and not scratched?
Does the monitored machine come to a halt on
positioning a test object (size > 250 mm) in the
light guard?
5.2

Cleaning

i
The light guard cannot be activated if the sensor lens
cover is contaminated.
¶
Clean the lens cover with a clean soft cloth. Use can
be made of a domestic detergent.
!
The use of corrosive or abrasive cleaning agents
which could damage the surface is not permitted.
5.3

Dispose of the PSC 2

1. Disconnect the PSC 2 from the mains and detach the
power cord.
2. Dismantle the PSC 2 and sort out and dispose of the
different materials in accordance with the applicable
regulations.
PSC 2, accessories and packaging should be
sorted for environmental-friendly recycling.
¶
Do not dispose PSC 2 into household
waste.
Only for EC countries:
The PSC 2 is subject to the European direc-
tive 2012/19/EC (WEEE).
Dispose of used electrical and electronic
devices, including cables, accessories and
batteries, separately from household waste.
¶
Make use of the local return and collection
systems for disposal.
¶
Proper disposal of PSC 2 prevents envi-
ronmental pollution and possible health
hazards.
6.

Technical Data

6.1

Basic data

Denomination
Sensor dimensions:
R Length
R Width
R Depth
OK?
Main assembly dimensions:
R Length
R Width
R Depth
Inspection pit:
Denomination
Maximum working pit width:
Ambient conditions:
Denomination
Operating Temperature
Relative humidity
(no condensation)
6.2

Sensors

Denomination
Max. current input:
R Transmitter
R Receiver
Maintenance | PSC 2 | 19
Value
1114 or 754
80
26
162
89,7
62,2
Value
1500
Value
-20 ... +45
< 80
Value
50
60
|
1 692 806 101
en
Unit
mm
mm
mm
mm
mm
mm
Unit
mm
Unit
°C
%
Unit
mA
mA
2018-05-18