Creative Sound BLASTER X7 Guía De Usuario página 16

Speaker Cables
There are different types of speaker cables or connectors that can be attached to the Speaker Output
terminals (Right and Left) of Sound Blaster X7. Ensure that the rubber covers are removed from the
binding posts before attaching the speaker cables.
i. Bare Wires
1. Turn the binding post of the Speaker Output terminal counter-clockwise to reveal the metal hole in
the binding post.
2. Tightly twist the bare wire and insert it into the hole. Ensure that the polarities of the wires match.
For example, connect the wire from the positive (red/white) terminal on each speaker to the
corresponding positive terminal on your receiver. Similarly, connect the wire from the negative
(black) terminal on each speaker to the negative terminal on your receiver.
3. Tighten the binding post to the speaker cable by rotating clockwise.
ii. Banana Plug
Simply push the banana plug into the binding post of the Speaker Output terminal. Ensure that the
polarities of the wires match.
1 2 3
Setting Up Your Audio Device - 15 -