Maintenance And Care - Felisatti SRF305/1800 Instrucciones De Servicio

follows:
Acoustic pressure, dB(A)
Sound-power level, dB(A)
Vibration acceleration, m/s
Use ear protection!
WARNING! The vibration level given in these
instructions has been measured in accordance with
a standardized measurement procedure specified in
EN60745 and can be used to compare devices. Different
uses of the device give rise to different vibration levels and
in many cases they may exceed the values given in these
instructions. It is easy to underestimate the vibration load
if the electrical power tool is used regularly in particular
circumstances.
Note. if you wish to make an accurate assessment of
the vibration loads experienced during a particular period of
working , you should also take into account the intervening
periods of time when the device is switched off or is running
but is not actually in use. This can result in a much lower
vibration load over the whole of the period of working.
ACCESSORIES
Accessories and their corresponding order number
can be found in our catalogues.

MAINTENANCE AND CARE

WARNING! For your own safety, turn the switch off
and remove the plug from the power source outlet before
maintaining or lubricating your mitre saw.
- The machine should be taken to a technical service
centre if the power falls.
- Tool inspection: Using a worn tool will reduce the
efficiency of the work being performed and could lead to
motor damage and the tools should be changed when any
abrasion is noted. Daily: Clean the tool holder.
- Inspect the mounting screws: Regularly inspect all
the mounting screws and ensure they are firmly tightened.
Should any screw be loose, tighten it immediately. Failure
to do so could put you at serious risk.
- Motor maintenance: Take the utmost care to ensure
that the motor winding is not damaged and does not
become damp with oil or water.
- Brush replacement: Have them replaced by an Official
Service Centre.
- Clean the machine thoroughly after each use with a
blast of dry air.
- The vents of the machine should be kept clear at all
times.
- Check that the mains lead is in good condition. If it is
not, take it to an Official Service Centre to have it replaced.
Use only FELISATTI accessories and spares. The
-
parts the changing of which is not covered in this instruction
manual, should be replaced in a FELISATTI Official Service
Centre (See Warranty/Official Service Centre address
leaflet).
WARRANTY
See general warranty conditions printed on the
attached sheet.
14
SRF305/1800 SRF305/1800 E
100.3 89.4
111.03 102.4
1.235 1.5
2
DISPOSAL
In accordance with European Directive 2002/96/EC
relating to old electrical and electronic appliances and
its translation into national law, used electric tools must
be collected separately and recycled in an ecologically
desirable way.