GRAPHITE 59G347 Manual Del Usuario página 11

TRANSLATION OF THE ORIGINAL INSTRUCTIONS
CAUTION: BEFORE USING THE POWER TOOL READ THIS MANUAL CAREFULLY AND KEEP IT FOR FURTHER USE.
When sanding wood and metal surfaces coated with paints with lead additives, harmful or toxic
dust may arise. Contact or inhalation of the dust may endanger operator's or other persons' health.
Use appropriate personal protection measures such as filter masks and safety glasses. Use dust
extraction system.
PRIOR TO SANDER OPERATION
During operation hold the sander firmly with both hands.
Ensure the abrasive paper does not touch processed material prior to switching the sander on.
Ensure the abrasive paper is well installed before switching the sander on.
Do not touch moving parts of the sander.
After switching off, do not put away the sander until all moving parts stop.
Use protective mask if the dust appears during sanding. Dust, which appears when sanding surfaces
coated with lead-based paint, some types of wood and metal, is harmful.
Pregnant women and children should not enter the room where lead-based paint is removed with the
use of sander.
Do not eat, drink or smoke in the room where lead-based paint is removed with the sander.
Avoid using long extension cords.
WHEN OPERATING THE SANDER
Wear earmuff protectors and protection half-mask always when using the sander.
Sander is not designed for wet operation.
Ensure the switch is in the OFF position before plugging the sander to power supply.
Keep the power cord away from moving parts of the sander.
Use safety goggles or glasses when operating the sander above head.
When operating the sander do not apply excessive pressure that might stop the tool.
CAUTION! This device is designed to operate indoors.
The design is assumed to be safe, protection measures and additional safety systems are used, ne-
vertheless there is always a small risk of operational injuries.
CONSTRUCTION AND USE
Orbital sanders are hand-operated power tools with insulation class II. Tools are driven by single-phase
commutator motors. Orbital sander is designed for sanding and polishing surfaces of wood, metal, plastic
and similar materials, with the use of sanding paper with appropriate gradation. Range of use covers repair
and building works, and any work from the range of individual, amateur activities (tinkering).
Do not use the sander for sanding surfaces that contain magnesium or asbestos, or covered with
gypsum.
DESCRIPTION OF DRAWINGS PAGES
Below enumeration refers to the device elements depicted on the drawing pages of this manual.
1. On/off switch lock button
2. On/off switch
3. Dust bag
4. Dust outlet
5. Sander backing pad
6. Rotational speed control knob (wheel)
* Differences may appear between the product and drawing.
ORBITAL SANDER
59G347
DETAILED SAFETY REGULATIONS
11