Preparation For Operation - GRAPHITE 59G347 Manual Del Usuario

MEANING OF SYMBOLS
CAUTION
WARNING
ASSEMBLY/SETTINGS
INFORMATION
EQUIPMENT AND ACCESSORIES
1. Dust bag
2. Sander backing pad 125 mm (attached to sander) – 1 piece
3. Sander backing pad 150 mm
4. Abrasive paper 125 mm (various grit sizes)
5. Abrasive paper 150 mm (various grit sizes)
6. Allen key
7. Transportation suitcase
CHOOSING SANDING PAPER
Coarse-grained sanding paper is used for coarse processing of most materials, while fine-grained paper is
used for finishing works.
When the surface is not flat, start the work with coarse-grained sanding paper and continue until the
surface is flat.
Next use middle-grained paper to remove traces of coarse processing.
To finish the work use fine-grained sanding paper.
INSTALLATION OF ABRASIVE PAPER
The sander features backing pad with hook-and-loop fastener (Velcro), which allows for easy and rapid
replacement of abrasive paper.
Hold abrasive paper close to backing pad (5), making sure that holes on the abrasive paper "a" match
holes on the backing pad then press to ensure effective discharge of dust (Fig. A).
To remove the abrasive paper, deflect it on one side and then pull it.
Use perforated abrasive paper, so the dust can reach extraction holes in the backing pad to dust
discharge installation. Each time prior to replacing used abrasive paper with a new one make sure
to remove dust and any contamination from the sander backing pad, using a tool such as brush of
paintbrush.
DUST EXTRACTION
Orbital sander features a dust bag for collecting dust (3) to maintain the processed surface clean.
Slide the dust bag mounting (3) onto the dust discharge outlet (4) and secure by turning it right (fig. B).
Check whether the dust bag is firmly fixed on the dust discharge outlet (4) by pulling it gently (the dust
bag is sealed with a rubber O-ring seal).
The dust bag is located in a plastic case. In order to empty it, the lower section of the plastic case must be
slid down, the dust bag must be taken out of its mount and its contents can be disposed of. The dust bag
must be fastened in the reverse order to the disassembly.
– 1 piece
– 1 piece
– 3 pieces
– 3 pieces
– 1 piece
– 1 piece

PREPARATION FOR OPERATION

12