Sauder 408364 Manual De Instrucciones página 8

Step 4
Fasten four METAL BRACKETS (J) to the ENDS (A and B) and
å
TOP (C). Use four BLACK 9/16" LARGE HEAD SCREWS (O).
Fasten the VALANCE (F) to the METAL BRACKETS (J). Use four
å
BLACK 9/16" LARGE HEAD SCREWS (O).
Unfold the BACK (D) and lay it over your unit.
å
Make equal margins along the top and sides of the BACK (D). Push
å
on opposite corners of your unit if needed to make it "square".
Fasten the BACK (D) to your unit using the NAILS (P).
å
NOTE: Perforations have been provided for access through the
å
BACK. Carefully cut out the holes needed.
BLACK 9/16" LARGE HEAD SCREW
(8 used for the METAL BRACKETS)
J
Page 8
O
B
C
F
J
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Do not put NAILS in
this edge at this time.
A
J
408364
P
NAIL
(19 used for the BACK)
Notch
D
www.sauder.com/services