Cleaning And Maintenance - Beaba MILK PREP Folleto De Instrucciones

2 times for a temperature of 37°C (bottle at body temperature).
3 times for a temperature of 48°C (warm milk, hot chocolate).
• Five beeps indicate the end of the cycle and the light flashes. Press the button once again to
stop the flashing light, then unplug the appliance.
• Lift the bowl by holding the handle and place it on a flat surface.
• Lift the lid with the attached stirrer.
• Pour the preparation into a bottle or a recipient.
• Check the temperature and give it to your child.
Note: The warning light ( ) will light up if the use of the product is incorrect (see table with
trouble shooting below).
Approximate heating
time

CLEANING AND MAINTENANCE

• Before cleaning, unplug the appliance and allow it to cool down completely.
• Never immerse the housing in water to clean.
• Wash the bowl, the lid and the stirrer with water and soap or in the dishwasher.
• Do not use corrosive detergent, detergent with chemical powders or hard metal
• wire mesh to clean, as this will damage the appliance surface, affect the service
• life and cause safety problems.
• To avoid any risk of burns do not touch the heating element with your hands.
• When not in use, clean and dry the appliance, and then put it into the packaging box and store
in a dry place with good ventilation.
• If needed, fill the bowl with water and white vinegar or the Béaba descaler product for
Babycook (100ml white vinegar + 100ml water).
• Leave to soak until deposits have completely disintegrated (one night).
• Rinse with clear water several times.
Heat to 22°C
1 to 3 minutes
14
Heat to 37°C
1 to 4 minutes
Heat to 48°C
2 to 6 minutes
TROU
The w
and th
The pr
right te
The m
homog
If you n
or conta
ENVI
• Do n
effec
Plea
poin