Torque Setting; Tool Change; Switching On/Off; Cleaning And Maintenance - Deltafox DP-CDR 2013 Traducción Del Manual De Instrucciones Original

GB
The direction changed may only
be performed in standstill mode.

Torque setting

You can preset the maximum torque by
rotating the torque adjustment ring (
21 torque settings + 1 drill setting are
provided.
1. Turn the adjusting ring (
the desired torque:
Step 1 -->
Step -->
Screws:
Drilling:
2. Start with a lower torque step and in-
crease according to requirement.
Torque adjustment should only be
performed in standstill mode.
Reaching the preset torque limit
produces a noticeable rasping
sound. This sound is caused by the
slip clutch.

Tool change

1. Rotate the keyless chuck (2)
counter-clockwise, until the
drill chuck aperture (1) is large
enough to accommodate the tool.
2. Push the tool as far as possible
into the keyless chuck (2).
3. Rotate the chuck clockwise to
clamp the tool firmly.
4. To remove the tool again, rotate
the keyless chuck (2) and pull out
the tool.
24
3) to select
lowest torque,
highest torque.
Steps 1 - 21
Step .

Switching on/off

By using the on/off switch (
can progressively control the speed. The
longer you push the on-off button, the
higher the speed.
3).
1. Press the on/off switch (5) to
start the device. The LED work
light (10) lights up during opera-
tion.
2. To turn it off, release the on/off
switch (9).
When you move the direction
switch (5) to the middle position,
the device is secured against
being switched on.
During breaks in work, the device
can be hung from a belt, using the
integral metal clip (6). Take care to
ensure that the device is switched
off and secured against accidental
activation.

Cleaning and maintenance

Contact our Service Centre about
repairs and servicing not de-
scribed in this manual. Only use
OEM parts. Risk of injury!
Turn off the appliance and, before
doing any servicing, remove the
battery.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.

Cleaning

Do not spray the appliance with
water and do not immerse it in
water. Electric shock hazard!
9) you